Flex-a-lite 52007 Camaro Radiator Kit Fits 1967-1969 First Gen Manuel d'utilisateur télécharger pdf

Camaro Radiator & Fan Kit #52187

or Camaro Radiator Kit #52007

Fits 1967-1969 “First Generation” Chevrolet Camaro

Notes: Measure for clearances prior to installation. May not be suitable within certain Big Block /

long water pump engine conﬁgurations.

Manual transmission preferred; automatic transmission requires a remote cooler.

INSTALLATION INSTRUCTIONS

Remove Existing Fan, Shroud & Radiator

BE SURE THE ENGINE IS COOL BEFORE PROCEEDING!!

Disconnect the negative (-) battery cable before proceeding with

the installation.

Utilizing the drain plug on the drivers side of the radiator, start

draining the coolant.

see Detail 1 It may be necessary to remove

the radiator cap to release the vacuum inside the radiator for better

draining.

Loosen, but do not remove, the four (4) bolts holding the fan to the

water pump.

Remove the screw securing top of fan shroud to bracket centered

above the radiator.

see Detail 2

Remove the upper and lower hoses from the radiator. It is not

necessary to remove them completely from the vehicle for

installation.

Remove fan belt by loosening top and bottom bolts of the alternator

bracket, then pivot alternator toward the water pump to relieve belt

tension.

Remove the four (4) bolts holding the fan to the water pump pulley.

Note: Save these bolts to be used later. Lift the original shroud and

fan out of the vehicle at the same time.

Remove shroud mounting bracket centered above radiator.

see Detail 2

If vehicle is equipped with an automatic transmission, remove both

inlet and outlet lines from passenger side of radiator.

see Detail 3

Remove bolts securing radiator to vehicle on both driver and pas

senger side. Note: you may need to remove battery and battery tray

to gain access to mounting bolts on passenger side. Save mounting

bolts removed from passenger side. You will be reusing these bolts

later.

Remove the original radiator by lifting it straight up. Note: Use cau-

tion while removing the radiator, it may still contain coolant which

can spill out.

10.

11.

12.

Detail 3

Disconnect

transmission

lines

Detail 1

Drain plug

Installation instructions continued on next page

Rev. 02-09-11 99187 Page 1 of 4

Detail 2

Shroud Mounting Bracket

1 2 3 4

Résumé du contenu

Page 1 - INSTALLATION INSTRUCTIONS

Camaro Radiator & Fan Kit #52187or Camaro Radiator Kit #52007Fits 1967-1969 “First Generation” Chevrolet CamaroNotes: Measure for clearances prior

Page 2 - Detail 4

Utilizing the included T-nuts (4 ea.), washers (4 ea.), and Lock nuts (4 ea.), mount bracket #51871 to the Driver’s side of the radiator; (studs shoul

Page 3 - Wiring Diagram

Wiring the Fan: Radiator and Fan Combo #52187 onlyWiring Diagramcoloredblackthickblackthick blackConnect the motor wires to the control module (Red wi

Page 4

Press the control knob (included in wiring kit) onto the control box shaft. Turn the knob clockwise until it stops. Reconnect negative (-) battery cab

Commentaires sur ces manuels

Pas de commentaire

Flex-a-lite 52007 Camaro Radiator Kit Fits 1967-1969 First Gen Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Pour la voiture Flex-a-lite 52007 Camaro Radiator Kit Fits 1967-1969 First Gen. Flex-a-Lite 52007 Camaro Radiator Kit Fits 1967-1969 First Generation Chevrolet Camaro User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Pour la voiture Flex-a-lite 52007 Camaro Radiator Kit Fits 1967-1969 First Gen