Flex-a-lite 328: puller with out controls LoBoy Fan & Alum Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Pour la voiture Flex-a-lite 328: puller with out controls LoBoy Fan & Alum. Flex-a-Lite 328: puller with out controls LoBoy Fan & Aluminum Shroud for Ford Coup 1930-34 User Manual Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 3
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
LoBoy Fan & Aluminum Shroud
for Ford Coup 1930-’34
Part #318: puller with controls
#328: puller with out controls
Assembly & Installation Instructions
1. First, attach the supplied fan to the fan shroud as
shown using the screws, washers, and nuts provided
(see
Diagram A
).
2. Prepare the radiator for shroud installation by
clearing the core surface.
3. Find the rubber strips included in the kit and
trim 2 strips to the length of the shroud. These
will be used between the shroud and radiator
to isolate vibration (see
Diagram B
).
4. The shroud can be mounted to the radiator by
using the flanges between your radiator tanks.
Place the shroud over the flanges. Using the
holes in the aluminum shroud as a template, mark
and drill holes through the flanges on your radiator.
It may be helpful to have a friend hold the shroud
while you mark and drill the holes.
NOTE: Use caution when drilling the mounting
holes. Do not drill into the radiator core!
5. Attach the fan and shroud assembly to the radiator
using the small #10 screws, and washers as shown
(see
Diagram B
).
NOTE: Be sure to use the rubber cushioning strips
between the shroud and radiator as shown!
Diagram A
Diagram B
Continue to next page
for wiring instructions
Rev. 07-13-10 99318 Page 1 of 3
Vue de la page 0
1 2 3

Résumé du contenu

Page 1 - Diagram B

LoBoy Fan & Aluminum Shroudfor Ford Coup 1930-’34Part #318: puller with controls #328: puller with out controlsAssembly & Installation I

Page 2 - WIRING DIAGRAM - MODEL #318

Fan Wiring Instructions; #318 with controls onlyStep 2: Locate mounting point for controlLocate a mounting point for control near inlet side of radiat

Page 3

Rev. 07-13-10 99318 Page 3 of 3Step 9: (Optional) For manual switch operation, use Flex-a-lite p/n 31148. Connect the switch as shownon the

Commentaires sur ces manuels

Pas de commentaire