Flex-a-lite 31149 Temp. Control Module Manuel d'utilisateur télécharger pdf

Wiring Diagram

1a. Connect the motor wires to the control module

(Red wire to the "M+" terminal and black wire to

the "M-" terminal).

1b. Disconnect the negative battery lead for

safety while finishing the wiring. Use the large

diameter red (10 AWG) wire to run power directly

from the battery positive (+) terminal to the "B"

terminal on the control module. Connect the fuse

holder in-line with this wire, as shown, but do not

insert the fuse yet. Use the yellow

female, ring, and butt connectors provided.

Part number 31149

Temp. Control Module

1c. Use the large diameter black (10 AWG) wire to

run from the negative (-) battery terminal to the "G"

terminal on the control module. Use the yellow

female connector and ring connector provided.

1d. Use the small diameter red wire (14 AWG) to connect the "+" terminal on the

control module to a positive power source.

NOTE: Attaching this wire to an

ignition-controlled source will shut off the fan when the engine is turned

off. Attach this wire to an uninterrupted (always hot) power source to allow

the fan to continue running after the engine is shut off.

Use the blue female

connector and fuse taps (included) if necessary.

10-07-05 part no. 99842 Page 1 of 2

1 2

Wiring Diagram1a. Connect the motor wires to the control module(Red wire to the "M+" terminal and black wire tothe "M-" terminal)

Page 2

1g. Use the zip ties provided to secure the wires and prevent them from interfering with fan blades,belts, and pulleys in the engine compartment. Re

Pas de commentaire

Flex-a-lite 31149 Temp. Control Module Manuel d'utilisateur