Flex-a-lite 345 Nissan 240SX Fits 1989-1998 Manuel d'utilisateur télécharger pdf

345

Nissan 240SX

Fits 1989-1998

INSTALLATION INSTRUCTIONS

Remove the lower engine splash shield. This will allow you to easily ac-

cess the radiator drain valve and the lower fan shroud.

Drain the coolant from the radiator. Use a clean drain pan and set it in a

clean spot so that the coolant can be reused (see Detail 1)

Remove the air intake tube. It’s easiest to disconnect it at the connec-

tion to the air ﬂow sensor block (see Detail 2).

Remove the radiator inlet hose and tie it back out of the way.

Remove the 2 bolts holding the lower portion of the fan shroud in place.

Remove the 2 clips holding the fan shroud ring in place.

Remove the bolt securing the air intake resonator/silencer located at the

bottom of the fan shroud.

Remove the hose and wire clips from the top of the fan shrou

Unplug the A/C fan wire harness (see Detail 3). This harness will be

used later when wiring the fan control unit. Remove and save the 2

bolts that attach the top of the A/C fan and the top of the shroud. These

will be used later to attach the new electric fan assembly. The factory

A/C fan will not be used and can be removed.

NOTE: FOLLOW ALL INSTRUCTIONS CAREFULLY TO AVOID PERSONAL INJURY AND

DAMAGE TO THE FAN, CONTROL MODULE, AND YOUR VEHICLE!

Detail 1

Detail 2 Detail 3

Detail 4

The resonator/silencer box

can’t be used with this kit.

Page 1 of 4 #98345 Rev. 05-17-10

Pull back the wires and hoses that run over the top of the shroud, then remove the top half of the shroud.

Remove the air resonator box. NOTE: The air resonator/silencer can’t be used with this electric fan.

Plug the hole in the air intake tube before reinstalling it to ensure no dirt or moisture enters the intake

tract (see Detail 4). Use the rubber cap included and secure it with a zip tie or hose clamp.

Remove the clutch fan. Replace the ﬂange nuts that held the clutch fan on as these also hold the pulley onto

the water pump.

Remove the lower half of the shroud and ring.

1 2 3 4

Résumé du contenu

Page 1 - Nissan 240SX

345Nissan 240SXFits 1989-1998INSTALLATION INSTRUCTIONSRemove the lower engine splash shield. This will allow you to easily ac-cess the radiator drain

Page 2 - OUT IN YOUR OWNER’S MANUAL!

Peel the protective vinyl coating off of the top and bottom brackets and attach them to the fan shroud with the screws provided as shown.Hold the fan

Page 3 - Wiring the Electric Fan

With the A/C drier relocated, now the fan assembly can be installed. Lower the fan assembly into place. Make sure the rubber caps ﬁt into the tabs a

Page 4 - WIRING DIAGRAM

Find the temperature probe attached to the control unit. Insert the temp. probe through the hole in the top bracket that is directly below the radiat

Commentaires sur ces manuels

Pas de commentaire

Flex-a-lite 345 Nissan 240SX Fits 1989-1998 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Pour la voiture Flex-a-lite 345 Nissan 240SX Fits 1989-1998. Flex-a-Lite 345 Nissan 240SX Fits 1989-1998 User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Pour la voiture Flex-a-lite 345 Nissan 240SX Fits 1989-1998